Select Previous Vehicles and Data from the Home screen.ģ. Once saved, the code scan report can be viewed on the diagnostic tool in the same manner it was displayed originally.ġ. A confirmation message is displayed indicating that the file was saved. Quick reference indicators are used to show system code status.Īfter the code scan has completed, select Save. The total number of systems analyzed is actively displayed at the top of the screen ( Figure 2). If you haven't seen it sign up for the 14 day free trial, bang out that series and then cancel before you have to pay if you don't want to keep the premium membership.Once you have connected and identified a vehicle through Scanner, select Code Scan ( Figure 1) from the Vehicle System menu to start an active scan of vehicle control modules. Most everything covered there applies to the Modis as well.
There's a video with instructions how to do it in the Scanner Danner Premium Verus training series. You'll be right where you left off, and you can click the meter tab on the windows task bar and the scope window will pop up and float over the scanner screen allowing you to use both. Now choose the home tab again, and scanner. It stays active on the windows task bar below. Tap it once to hide the on screen instructions, and once more puts the scope screen into it's own window. Once you have the correct test lead chosen on the correct channel, your probes hooked up and scales are set, at the top of the scope screen is a tab that says meter. It really doesn't matter which one because you're going to configure the scope to your liking anyway. You must choose this, not lab scope, or it won't work. This will keep the scanner running but bring you back to the diagnostic suite. Tap the home tab at the bottom of the screen. So imagine you have the scanner all set up to control your output, but you want to verify with the scope.
It's kind of a chore, but I do it regularly. There is a way to use the use scope and scan tool at the same time. Is there also a better scanner/scope on the market? Say Autel? Or Launch? I don't know much about them, just trying to get as much info before I jump to the Modis Edge. and I can jump to a Modis Edge for $3000 with my trade in, so I am getting my moneys worth back on my Solus Ultra, even with a broken screen, and saving ~$2000 for the Modis Edge. It is multiple years newer with the latest software and it gives me access to a scope.
What I really want to know is, is the Modis worth it to upgrade to it. So I have knowledge of the Snap-On scanner and scope functionality. I like the functionality of the Modis Edge (also its quicker) and I learned to use a Vantage Ultra scope when I was in trade school. My snap-on rep has let me loan a Modis Edge for a little bit to see if I'd want to switch into that.
I have been looking for a scope/scanner recently, and I currently own a Snap-On Solus Ultra (updated to 19.2) (kinda old hardware, and I have a cracked screen) I have been thinking about getting the screen repaired, and updating it to the latest software.(Screen replacement because I get freezing up and touch calibration everytime I start the scanner) So I would be spending 1000-1500 to get it repaired and updated.